Sage Bambino Plus · BES500 / SES500

Bambino Plus Guide

Making espresso, dosing, steaming milk, cleaning and descaling, step by step. Everything here comes from the official Sage user guide.

Step by step

Pick a task. The machine shows which buttons to press and what happens.

No buttons to press
MAX DESC INSERTLOCK
Step 1 of 5

Step

    Dose and tamp

    Choose your basket to see how much coffee goes in.

    15–20 kg 2 Cup basket
    16–19 g

    of ground coffee

    Use for
    Freshly ground whole beans. You control grind, dose and tamp.
    Level
    Tap the portafilter a few times so the grounds sit flat.
    Tamp
    Press firmly and evenly, about 15–20 kg. The tamper's metal edge should end level with the basket rim.
    Trim
    Rest the Razor tool on the rim, twist it back and forth over a knock box, then wipe the rim clean.

    Read your shot

    Watch when the first drops appear and how the coffee flows. Change one thing at a time, then try again.

    30 s simulated, sped up

    Care schedule

    Dark tags mean the machine tells you when it's time.

    Never use abrasives, scouring pads or the dishwasher on any part. Use cold tap water, not distilled or demineralised water.

    Button combos

    1 CUPAbout 30 ml single shot. Stops by itself. Press again to stop early.
    2 CUPAbout 60 ml double shot.
    1 CUPholdManual pre-infusion. Let go to start the shot, press the flashing button to stop.
    1 CUP+2 CUP2 sProgram shot volume. Then press 1 CUP (or 2 CUP) to start and again to stop. That volume is saved.
    1 CUP+MILK FOAMHot water from the wand (lift it first). Press 1 CUP to stop.
    1 CUP+STEAMTurn off.
    STEAM5 sManual purge of the steam wand (wand down).
    1 CUP+2 CUP5 sStart cleaning mode when asked. When the machine is off: reset shot volumes to factory settings.
    2 CUP+STEAM5 sMachine off: run a cleaning cycle early.
    1 CUP+STEAM5 sMachine off and cool: enter descale mode.

    If something's off

    Coffee only drips, or doesn't come out

    Grind coarser, use less coffee and trim with the Razor, tamp at 15–20 kg, clear the basket holes. If nothing helps, descale.

    Coffee runs too fast

    Grind finer, add a little more coffee, and tamp at 15–20 kg.

    No crema

    Tamp firmly, grind finer, use fresher beans, clear the basket. Use a dual wall basket with pre-ground coffee.

    Coffee leaks around the portafilter

    Turn the portafilter fully to LOCK, wipe the basket rim, and use a little less coffee.

    Coffee isn't hot enough

    Warm the portafilter under hot water and dry it before dosing.

    Milk too hot

    Make sure the jug sits on the sensor, then lower the MILK TEMP setting.

    No steam, or TEMP and FOAM lights flash

    The wand may be blocked or the tank empty. With the wand down, hold STEAM to purge, then refill the tank. Wait for warm-up, or descale.

    Buttons stay dark

    The tank is low or not pushed fully down. Fill it and seat it until all buttons light.

    Water in the drip tray, pulsing noises

    Both are normal. The wand and group head purge into the tray, and the pump pulses as it works.

    Machine is on but does nothing

    The thermal cut-out may have tripped. Hold 1 CUP + STEAM for 5 s, unplug, and let it cool 30–60 minutes. If it keeps happening, contact Sage Support.